Documentation/Engine/Units/accessory addon trailer cables data< Documentation | Engine | Units
Note: This article is a work in progress and has yet to be reviewed by SCS staff. Some information may be incomplete or inaccurate.
The accessory_addon_trailer_cables_data unit class is used for adding dynamic trailer cables between a vehicle and its trailer. For player trucks, units of this type are usually defined in /def/vehicle/truck/<brand.model>/accessory/trlr_cables/*.sii and valid unit names end in
.trlr_cables. For player trailers, units of this type are usually defined in /def/vehicle/trailer/<trailer_name>/accessory/trlr_cables/*.sii and valid unit names end in
.trlr_cables. This unit type was added in 1.31.
Many common attributes are inherited from accessory_data.
|exterior_model||string||Path to the model descriptor (.pmd) for the model to be displayed in the exterior view (if applicable).|
|exterior_model_uk||string||Path to the model descriptor (.pmd) for the model to be displayed in the exterior view for left-hand drive vehicles (if applicable). If unset, defaults to exterior_model.|
|coll||string||Path to the collision descriptor (.pmc) for the accessory (if applicable).|
|look||token||default||Name of the look to be used on all descriptors of this accessory.
Note: All models for an accessory must have the same set of looks.
|variant||token||default||Name of the variant to be used on all descriptors of this accessory.
Note: All models for an accessory must have the same set of variants.
|cables||array<owner_ptr>||Each member points to a physics_trailer_cable_data unit|
A valid trailer cables accessory model must have the following:
- Some visible geometry (models cannot contain only locators)
- Attachment locators for each member defined in the cables array, where the truck plug model will be placed. The locator names are defined by each physics_trailer_cable_data unit's locator_prefix attribute.
It may additionally make use of the following:
- Rest locators for each defined cable where the trailer plug model will be placed when there is no trailer connected (otherwise the cable will not be drawn/simulated when there is no trailer connected). The locator names are defined by each physics_trailer_cable_data unit's rest_locator_prefix attribute.
- Special part names are displayed only during particular states:
cables_offis displayed only when no trailer is attached
cables_onis displayed only when a trailer is attached