Documentation/Engine/Units/accessory cabin data

The accessory_cabin_data unit class configures the models for the cabin of the player's vehicle. Units of this type are found in /def/vehicle/truck/<make.model>/cabin/.

Attributes

Many common attributes are inherited from accessory_data.

Name	Type	Description
detail_model	string	Path to the high level-of-detail mesh. This is generally unused, but can be used for fine detail or ‘expensive’ shader effects that are only visible very close to the vehicle.
model	string	Path to the standard level-of-detail mesh. If only a single LOD is used, it should be set up as model, and the other attributes (detail_model, lods) should not be defined.
lods	array<string>	Paths to the reduced level-of-detail meshes, in order of increasing viewing distance (decreasing model complexity).
collision	string	Path to the collision mesh (.pmc).
variant	token	Selects the variant to be used for all models/collisions defined. This is required if the cabin and chassis share a model as is currently the standard practice in ETS2 and ATS. Default value is default. Note: All models defined for this accessory_cabin_data must have this variant name.
variant_uk	token	Selects the variant to be used for all models/collisions for right-hand-drive (RHD) vehicles. If unset, defaults to the same value as variant. Note: All models defined for this accessory_cabin_data must have this variant name.
look	token	Selects the look to be used for all models defined. Default value is default. Note: All models defined for this accessory_cabin_data must have this look name.
wiper_model	string	Path to the animated wiper model (.pmg)
wiper_anim	resource_tie	Path to the wiper animation (.pma)
wiper_model_uk	string	Path to the animated wiper model (.pmg) for RHD vehicles. If unset, defaults to the value of wiper_model.
wiper_anim_uk	resource_tie	Path to the wiper animation (.pma) for RHD vehicles. If unset, defaults to the value of wiper_anim.
drl_with_headlights	float	Sets the relative strength of the daytime running lights when the headlights are on. For the DRL to be off when the headlights are on, a value of 0 is used. If the DRL should stay on and not dim when the headlights are on, a value of 1 is used. An intermediate value will dim the DRL when the headlights are on, and a value greater than 1 will intensify the DRL when the headlights are on. The typical value in ETS2 is 0.4.
toll_tag	string	Currently unused.
suspension	bool	When true, physical simulation of cabin air suspension is enabled.