Sounds - The truck chassis

Another group of truck sounds are sounds tied to the truck chassis.

Air Brake

Brake discharge air sound effect. It has to be 3D event. The event should be routed to the "truck_effects" audio bus. This is a simple ("one shot") event. It is recommended to use randomization of the assets supported by FMOD Studio.

The following event parameter must exists:

air_pressure - the value is in the range <0 - 1> and represents the relative pressure of the air system

Air CutOff

Cutoff air sound effect. It has to be 3D event. The event should be routed to the "truck_effects" audio bus. This is a simple ("one shot") event. It is recommended to use randomization of the assets supported by FMOD Studio.

Reverse

Back-up beeper sound. It has to be 3D event. The event should be routed to the "truck_effects" audio bus. The event must be looped.

Lift Axle

Sound effect of lifting axle. It has to be 3D event. The event should be routed to the "truck_effects" audio bus. The event must be looped or can be "one shot" sound but long enough.

Hook Attach

Sound effect of attaching hook. It has to be 3D event. The event should be routed to the "truck_effects" audio bus. This is a simple ("one shot") event.

Hook Detach

Sound effect of detaching hook. It has to be 3D event. The event should be routed to the "truck_effects" audio bus. This is a simple ("one shot") event.

Trailer Cables

Sound effect of the trailer cables connection. It has to be 3D event. The event should be routed to the "truck_effects" audio bus. This is a simple ("one shot") event.

Sound Configuration

The group of sounds configuration is stored in the "accessory_chassis_data" data.

There is no mandatory events but there is no default events either. Only the defined sounds will be played. There is array "sounds" which contents specification for the events:

air_brake
air_cutoff
reverse
lift_axle
hook_attach
hook_detach
trailer_cables

Example

There are configuration files for chassis for the "Peterbilt 579" inside folder "/def/vehicle/truck/peterbilt.579/chassis".

Each accessory include @include "sound.sui" file which contents indirect definition of the events:

	sounds[]: "air_brake|/sound/truck/default/effects_air_brake.soundref"
	sounds[]: "air_cutoff|/sound/truck/default/effects_air_cutoff.soundref"
	sounds[]: "reverse|/sound/truck/default/effects_reverse.soundref"
	sounds[]: "lift_axle|/sound/truck/default/effects_lift_axle.soundref"
	sounds[]: "hook_attach|/sound/truck/default/effects_hook_attach.soundref"
	sounds[]: "hook_detach|/sound/truck/default/effects_hook_detach.soundref"
	sounds[]: "trailer_cables|/sound/truck/default/effects_trailer_cables.soundref"

Sound Position

The 3D position of this sounds is (by default) the same position as the engine.
This position could be modified by the .soundref file. (see Sound reference file)

Documentation/Engine/Sound/TruckChassis

Contents